How to install the 3945ABG Driver on a fresh FreeBSD 6.2 install?

[Daniel Tourde]

Hello again,


> > I hate to say this but this driver only seems to compile on -CURRENT as
> > far as i can tell (and as far as the conversation at
>
> I don't remember from where I downloaded it, but this one [attached]
> works fine on 6-STABLE for me!
> make
> make install
> kldload if_wpi

I built it. It works but it complains and sometimes it shuts down itself... 
That would be nice to know where to report the error messages


Jan 18 20:23:59 guenevere kernel: config chan 6 flags 8035 cck f ofdm 15
Jan 18 20:23:59 guenevere kernel: wpi0: link state changed to DOWN
Jan 18 20:23:59 guenevere kernel: scan finished
Jan 18 20:24:30 guenevere last message repeated 6 times
Jan 18 20:24:50 guenevere last message repeated 4 times
Jan 18 20:24:55 guenevere kernel: rx tail flags error 702
Jan 18 20:24:55 guenevere kernel: scan finished
Jan 18 20:25:26 guenevere last message repeated 6 times
Jan 18 20:26:52 guenevere last message repeated 17 times
Jan 18 20:26:52 guenevere kernel: config chan 6 flags 8035 cck f ofdm 15
Jan 18 20:26:52 guenevere kernel: config chan 6 flags 8035
Jan 18 20:26:52 guenevere kernel: wpi0: link state changed to UP
Jan 18 20:26:59 guenevere dhclient: New IP Address (wpi0): 192.168.1.7
Jan 18 20:26:59 guenevere dhclient: New Subnet Mask (wpi0): 255.255.255.0
Jan 18 20:26:59 guenevere dhclient: New Broadcast Address (wpi0): 
192.168.1.255
Jan 18 20:26:59 guenevere dhclient: New Routers (wpi0): 192.168.1.1
Jan 18 20:28:52 guenevere kernel: rx tail flags error 702
Jan 18 20:29:24 guenevere last message repeated 3 times
Jan 18 20:31:15 guenevere last message repeated 6 times


Daniel