gmirror insert question
Alban Hertroys
dalroi at solfertje.student.utwente.nl
Thu Oct 13 11:23:14 PDT 2005
I can't seem to get gmirror insert to work. I have these partitions
/dev/ad8s2d and /dev/ad10s2d that I want to mirror (among others). I
did as follows (from single user mode):
$ gmirror label -v -b load var /dev/ad8s2d
$ gmirror insert var ad10s2d
But ad10s2d fails to synchronize (error 1), and the mirror stays
degraded (even though there's only 1 partition in it; isn't that a bit
odd?).
The exact output is (typed over from the console):
GEOM_MIRROR[1]: Adding disk ad10s2d to var.
GEOM_MIRROR[0]: Provider ad10s2d detected.
GEOM_MIRROR[0]: Device var: rebuilding provider ad10s2d.
GEOM_MIRROR[0]: Synchronization request failed (error=1).
ad10s2d[WRITE(offset=0, length=131072)]
GEOM_MIRROR[0]: Device var: provider ad10s2d disconnected.
GEOM_MIRROR[0]: Device var: rebuilding provider ad10s2d stopped.
GEOM_MIRROR[1]: Consumer mirror/var destroyed.
GEOM_MIRROR[1]: Consumer ad10sd destroyed.
The same goes for /, /usr and /home. I'd like to get this working. In
addition I would like to create some striped partitions in a similar
way; for /tmp, /usr/obj and /usr/ports - I think those'll be run async
w/o softupdates.
Any help appreciated.
Alban Hertroys http://solfertje.student.utwente.nl
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
This person has performed an illegal operation
and will be shot down.
More information about the freebsd-questions
mailing list