Qlogic ISP 2200, DL-380 and EVA 5000 SAN; how?
m at mongers.org
Tue Feb 22 08:43:34 GMT 2005
On 2005-02-21 10:29:48 -0600, Dan Nelson wrote:
> In the last episode (Feb 21), Morten Liebach said:
> > I am trying to use a HP EVA 5000 SAN through a Qlogic ISP 2200 PCI
> > FC-AL Adapter on a HP DL-380 (dmesg inline at the end), and so far
> > I've failed.
> > The HBA is recognized as:
> > isp0: <Qlogic ISP 2200 PCI FC-AL Adapter> port 0x4000-0x40ff mem 0xf7ff0000-0xf7 ff0fff irq 10 at device 1.0 on pci6
> > I need to run 'camcontrol rescan all' to see anything more than the
> > built in RAID, with ISP_TARGET_MODE and ispfw(4) compiled in. After
> > running 'camcontrol rescan all' I get:
> > # camcontrol devlist -v
> > scbus3 on isp0 bus 0:
> > <COMPAQ HSV110 (C)COMPAQ 3020> at scbus3 target 0 lun 0 (pass1)
> > < > at scbus3 target -1 lun -1 ()
> > scbus-1 on xpt0 bus 0:
> > < > at scbus-1 target -1 lun -1 (xpt0)
> > I've been trying to rescan 3:0:0 and 3:0:1 and various other
> > combinations. The SAN should have the volume available at LUN 1,
> > according to our storage manager, but nothing is found there.
> Check your LUN masking; have you made it visible to this host (usually
> by specifying the server's port or WWID)? Masking can be done at
> either the RAID or the fibre-switch. Switches usually do masking at
> the port or wwid level, so since you can see LUN 0 of that array, it's
> probably being masked at the RAID array.
These things look OK, we have both Linux, Windows and HP-UX hosts on the
same SAN with the same setup for them.
> > isp0: <Qlogic ISP 2200 PCI FC-AL Adapter> port 0x4000-0x40ff mem 0xf7ff0000-0xf7ff0fff irq 10 at device 1.0 on pci6
> > pass1 at isp0 bus 0 target 0 lun 0
> > pass1: <COMPAQ HSV110 (C)COMPAQ 3020> Fixed Storage Array SCSI-2 device
> > pass1: 100.000MB/s transfers, Tagged Queueing Enabled
> LUN 0 looks like it's just a management LUN. A disk device would come
> up as "Direct Access", not "Storage Array".
Thanks, and have a nice day
More information about the freebsd-questions