IPFW pipe command
Malcolm Clarke
malcolm.clarke at brunel.ac.uk
Sat Dec 17 17:27:52 PST 2005
I have a question regarding use of the "pipe" command in IPFW.
I use the following commands
#ipfw add pipe 1 ip from any to any
#ipfw pipe 1 config
but get the following error
ipfw: setsockopt(IP_DUMMYNET_CONFIGURE): Protocol not available
I have added firewall_enable="YES" in rc.conf
Is there a setting I need to set or change
Regards
Malcolm
--
---------------------------------------------------
Dr Malcolm Clarke
Senior Lecturer in Data Communication Systems and Telemedicine
Department of Information Systems and Computing
Brunel University
Uxbridge
Middlesex
UB8 3PH
UK
Tel: +44 1895 265053
Fax: +44 1895 251686
----------------------------------------------------
More information about the freebsd-questions
mailing list