FAILURE - SETFEATURES SET TRANSFER MODE status=41

[Jimmy Bäckström]

Alex Zbyslaw wrote:

> Jimmy Bäckström wrote:
>
>> Hi list!
>> I've googled and searched the mailing list archives for this but 
>> couldn't find anything useful.
>> I just installed freebsd 5.4 on a dell PE 2850 with RAID5 (PERC). The 
>> installation goes fine and as far as I can tell it runs ok, haven't 
>> really done anything with yet though so I can be wrong, but when 
>> booting I get two messages that concerns me:
>>
>> ata2-master: FAILURE - SETFEATURES SET TRANSFER MODE 
>> status=41<READY,ERROR> error=4<ABORTED>
>> ata2-slave: FAILURE - SETFEATURES SET TRANSFER MODE 
>> status=41<READY,ERROR> error=4<ABORTED>
>>
>> and
>>
>> Interrupt storm detected on "irq18: uhci2"; throttling interrupt source
>>
>> When it comes to the ata2-master/slave errors I understand that they 
>> happen for quite a few people running later versions of freebsd? I 
>> haven't found anything on the net that points directly at my hardware 
>> specifics, it seems to happen to a lot of different drives. I'm using 
>> 4 seagate harddrives by the way.
>>
>> If this problem has been adressed on the list before, I apologise, I 
>> couldn't find anything about it. I appreciate any pointers and if 
>> someone wants me to post dmesg just ask.
>>
> Set up two of these servers recently.
>
> We totally ignored the interrupt storm.  We couldn't make it go away 
> but it seemed to do no harm.
>
> The ata errors are froeither related to the DRAC virtual devices, or 
> the real CD, if you have one.  They seem to confuse atapicam.  If you 
> take atapicam out of the kernel the messages will go away.  Your hard 
> drives are SCSI and have nothing to do with ata.
>
> --Alex
>
>
> _______________________________________________
> freebsd-questions at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-questions
> To unsubscribe, send any mail to 
> "freebsd-questions-unsubscribe at freebsd.org"
>
Doh!
Didn't even think about the drives being SCSI. My bad. :)
About atapicam, I can't find it in the kernel config, what line should I 
be looking for?Re:

-- 
Vänligen/regards
Jimmy Bäckström
Support
Crystone AB
www.crystone.se