howto load or install wlan_wep module on freeBSD 5.4 ?

[PK]

yes, but cable is disabled at the moment 

I think there is a problem with DS/1Mbps
this driver seems to allow by default the transfer rate: 1 Mbps 

my wlan access point accept only 54Mbps !

I think I must change to 54Mbps using ifconfig

Do you know, howto change this ?

# ifconfig ath0 media DS/54Mbps
ifconfig: unknown media subtype: DS/54Mbps
 




 --- On Mon 08/08, Andrew L. Gould < algould at datawok.com > wrote:
From: Andrew L. Gould [mailto: algould at datawok.com]
To: piotrekk at excite.com
     Cc: freebsd-questions at freebsd.org
Date: Mon, 8 Aug 2005 16:07:11 -0500
Subject: Re: howto load or install wlan_wep module on freeBSD 5.4 ?

On Mon,  8 Aug 2005 16:57:44 -0400 (EDT)<br>"PK" <piotrekk at excite.com> wrote:<br><br>> <br>> 1. Poor signal strength<br>> <br>> no, very good (1 meter distance)<br>> windows installed on the same machine shows 100% <br>> <br>> 2. Improperly configured nameserver information (/etc/resolv.conf)<br>> <br>> it's correct, because with ethernet nic works well<br>> <br>> 3. Improperly configured default gateway<br>> <br>> it's correct, otherwise I cannot ping the default router from<br>> the ethernet nic<br>> <br>> other question<br>> <br>> howto set (change) DS/1Mbps to 54Mbps ? <br>> <br>> <br><br>Do you have your cable and wireless interfaces configured to the same<br>network?<br><br>Andrew Gould<br>

_______________________________________________
Join Excite! - http://www.excite.com
The most personalized portal on the Web!