Intel PRO/1000 and Intel 865 PE, FreeBSD 5.2.1
Ighor
mail at furgon-center.ru
Wed Sep 8 04:57:04 PDT 2004
*This message was transferred with a trial version of CommuniGate(tm) Pro*
Good day, Andras.
18 aug 2004 , 20:44:42:
AK> -----Original Message-----
AK> From: owner-freebsd-questions at freebsd.org
AK> [mailto:owner-freebsd-questions at freebsd.org] On Behalf Of Ighor
AK> Sent: Wednesday, August 18, 2004 4:18 AM
AK> To: questions at FreeBSD.org
AK> Subject: Intel PRO/1000 and Intel 865 PE, FreeBSD 5.2.1
AK> Good day!
AK> Sorry about my stupid questions, but i can't resolve my problem by
AK> myself. I've read a lot of pages and FAQs but can't do this:
AK> I have Intel PRO/1000 Network Card on Albatron motherb PX865PE ProII
AK> oard with Inter 82865PE chipset.
AK> After boot network card doesn't work. I think it's something with
AK> interrupts. It only works when I disable ACPI in device.hints. The the
AK> card uses IRQ18 and all is ok.
AK> I've shitched resources in BIOS in thousands combinations - it's all
AK> the same.
AK> I need ACPI for HT pseudo-dual processing.
AK> There are two logs attached - with ACPI and without
AK> Thank you if you can help me.
AK> Hello Ighor,
AK> I had an Intel 865PERL Board + P4 3.0 800 HTT CPU
AK> 5.2.1 always crashed because some ACPI compatibility problem...
AK> I upgraded to a 5.2 Current which solved the ACPI issues.
AK> Replaced that board to a ASUS p4c800-e deluxe which never had any problem
AK> since..
AK> Try firmware upgrade on the motherboard or try test with Current
AK> Best regards,
AK> Andras Kende
AK> http://www.kende.com
I've changed motherboard to Albatron on i865PE and 3Com NIC (xl
driver).
Now it says:
===
...
Sep 7 18:49:23 kernel: pci0: <serial bus, USB> at device 29.7 (no driver attached)
Sep 7 18:49:23 kernel: pcib2: <ACPI PCI-PCI bridge> at device 30.0 on pci0
Sep 7 18:49:23 kernel: pci2: <ACPI PCI bus> on pcib2
Sep 7 18:49:23 kernel: xl0: <3Com 3c905C-TX Fast Etherlink XL> port 0xa000-0xa07f mem 0xfb000000-0xfb00007f irq 20 at device 0.0 on pci2
Sep 7 18:49:23 kernel: xl0: Ethernet address: 00:0a:48:0c:89:a3
Sep 7 18:49:23 kernel: xl0: no PHY found!
Sep 7 18:49:23 kernel: device_probe_and_attach: xl0 attach returned 6
...
===
And still does not work.
Hardware is 100% ok.
I'm panic.
--
Best regards,
Ighor Poterakhin
ICQ UIN 65975280, phone +7-916-7219187
More information about the freebsd-questions
mailing list