scsi tape errors
David.Bear at asu.edu
Wed Mar 17 08:13:03 PST 2004
Thanks for the advice. I appreciate all the insights.
However, my experience suggest that either I'm doing things very
wrong, or I'm using the wrong hardware for BSD.
Since the kernel dumps so much information when the scsi bus behaves
strangely, isn't there some way to decode from the kernel messages
what could really be happening? I ran a full system dump to a tape
yesterday. The dump proceeded without error untill it fill the tape,
35 gig. When I put in a new tape, then things began to act strangely.
After a full power down and reboot, things are still misbehaving.
When I attempt to read the tape the dump wrote without error, I get
i/o errors. Even commands like "mt status" and "mt offline" cause the
input/output error message... and lots of kernel messages similar to
what I posted.
I'm beginning to wonder if my scsi card has something wrong with it.
There's got to be a better way to trouble shoot/track down, diagnose
btw, I am using an adaptec 29160 wide card.. I am using a wide cable
to connect the externel tape unit. And I am using an active terminator
on the tape unit. (It does have an LED to signify I guess that it is
powered) Are there any additional tools that I can use to check
whether this is really a tape device issue, a scsi device issue...
On Tue, Mar 16, 2004 at 09:18:03PM -0600, Dan Nelson wrote:
> In the last episode (Mar 16), David Bear said:
> > I am getting error messages that don't make much sense. They would
> > lead me to beleive that the tape is bad... I guess. Yet, I have a
> > hard time beleiving that the two out of four tapes is bad.
> > issuing an 'mt erase' it get an input/output error.
> > below are the kernel messages.
> > could two tapes suddenly just become 'bad'?
> > Since these are ait tapes and have a 64k ram buffer, I'm wondering if
> > there may be some bad data there and if there is a way to clear it...
> > The tape unit is a sony sdx300c. I've updated it to the latest
> > firmware. Its attached to an adaptec 2940wide.
> Is it possible that erasing an AIT tape takes more than 4 minutes?
> That's how long the cam layer will wait for an erase command to
> complete. Try adding
> options SA_ERASE_TIMEOUT=10*60
> and rebuilding your kernel.
> Dan Nelson
> dnelson at allantgroup.com
College of Public Programs/ASU
Wilson Hall 232
Tempe, AZ 85287-0803
"Beware the IP portfolio, everyone will be suspect of trespassing"
More information about the freebsd-questions