Using portsupgrade with make arguments

[Jeff Hinrichs]

----- Original Message ----- 
From: <dev at eth0.ch>
To: <freebsd-questions at freebsd.org>
Sent: Tuesday, April 20, 2004 2:23 PM
Subject: Using portsupgrade with make arguments


> Hi all,
>
> just to get it clear for me: If I upgrade a port that has been originally
> installed with additional make arguments I must include them again. Is the
> following correct?
>
> Original installation:
> # make arg_1=val_1 arg_2=arg_2 install clean
>
> Upgrading port using portupgrade:
> # portupgrade -R -m "arg_1=val_1 arg_2=arg_2" port
 Even better, use pkgtools.conf
-jeff