sym: where did my drives go?

[Per olof Ljungmark]

Hi all,

I'm assembling a Compaq 1850R with attached storage system. For the 
built in scsi controller, there are three drives internally on channel 1 
+ 5 drives externally on channel 2.
During boot, I can see all disks being identified first by the machine 
itself and then in the early part of the process, by the kernel 
(something scrolls by talking about BIOS drive numbering).

However, the result is not 8 drives but 5 in total in a mix between the 
channels, see below.

What's wrong? Do I need to make more devices? If yes, how?

Thanks,

da0 at sym0 bus 0 target 0 lun 0
da0: <COMPAQ AB00931B92 3AS8> Fixed Direct Access SCSI-2 device
da0: 40.000MB/s transfers (20.000MHz, offset 15, 16bit), Tagged Queueing 
Enabled
da0: 8678MB (17773500 512 byte sectors: 255H 63S/T 1106C)
da4 at sym1 bus 0 target 4 lun 0
da4: <COMPAQ MAB3091SC 0814> Fixed Direct Access SCSI-2 device
da4: 40.000MB/s transfers (20.000MHz, offset 16, 16bit), Tagged Queueing 
Enabled
da4: 8678MB (17773500 512 byte sectors: 255H 63S/T 1106C)
da2 at sym0 bus 0 target 2 lun 0
da2: <COMPAQ AB00931B92 3AS8> Fixed Direct Access SCSI-2 device
da2: 40.000MB/s transfers (20.000MHz, offset 15, 16bit), Tagged Queueing 
Enabled
da2: 8678MB (17773500 512 byte sectors: 255H 63S/T 1106C)
da3 at sym1 bus 0 target 3 lun 0
da3: <COMPAQ AB00931B92 3AS8> Fixed Direct Access SCSI-2 device
da3: 40.000MB/s transfers (20.000MHz, offset 15, 16bit), Tagged Queueing 
Enabled
da3: 8678MB (17773500 512 byte sectors: 255H 63S/T 1106C)
da1 at sym0 bus 0 target 1 lun 0
da1: <COMPAQ AB00931B92 3AS8> Fixed Direct Access SCSI-2 device
da1: 40.000MB/s transfers (20.000MHz, offset 15, 16bit), Tagged Queueing 
Enabled
da1: 8678MB (17773500 512 byte sectors: 255H 63S/T 1106C)