Setup Virtual Server Port on HP Proliant Server ...
Marc G. Fournier
scrappy at hub.org
Wed Dec 13 02:13:25 PST 2006
-----BEGIN PGP SIGNED MESSAGE-----
- --On Wednesday, December 13, 2006 05:36:13 -0400 "Marc G. Fournier"
<scrappy at hub.org> wrote:
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
> 'k, I've drop'd -stable off of this ...
> Did some searching, found the HP Lights-Out VSP Configuration guide ... I
> think everything is setup right in the BIOS ... VSP is on COM2 (default),
> EMS points to COM2 ... run VSP through iLO/web the message:
> Virtual Server Port active: IO=0x02F8 INT=3
> so, COM2 ...
> But, in /dev, I have no device ... because I need sio build into my kernel,
> 'k ... going to do that next ...
Getting closer ... still missing something though ...
Have a getty on ttyd1, and a Login: prompt ... but I still can't seem to send a
According to the VSP config guide, <ESC>Ctrl-B should do it ...
Do I have to setup the comconsole stuff in /etc/loader.conf as well, for the
break to work?
Damn, now I screwed up the server ... no remcons, and nothing on the vsp ...
all I have left is:
to /boot/loader.conf ...
So, that was the wrong move ... :(
Marc G. Fournier Hub.Org Networking Services (http://www.hub.org)
Email . scrappy at hub.org MSN . scrappy at hub.org
Yahoo . yscrappy Skype: hub.org ICQ . 7615664
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.5 (FreeBSD)
-----END PGP SIGNATURE-----
More information about the freebsd-proliant