[Fwd: Pismo Success]

[Pete Carss]

Hello All

I have successfully installed 7.0-20051105-SNAP on a 400Mhz G3 Pismo. I
had to setup a local ftp server to get around the lack of CD drive. I
also tried an external firewire drive with no success.

I left a 32Mb hfs+ partition, which I mounted on another mac, by putting
the Pismo into target disk mode, then copied loader over.

then...

setenv boot-device hd:loader hd:11
reset-all

in OpenFirmware and I've got FreeBSD on a laptop.

Where should I start hacking to get ADB support?

What's the status of power management? I got a few instant offs when I
unplugged from the mains...


Thanks for the work

Pete

Copyright (c) 1992-2005 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD 7.0-20051105-SNAP #0: Sat Nov  5 04:33:52 UTC 2005
     root at macmini.ptree32.com.au:/usr/obj/usr/src/sys/GENERIC
Timecounter "decrementer" frequency 24966218 Hz quality 0
cpu0: Motorola PowerPC 750 revision 2.2, 400.00 MHz
cpu0: HID0 8090c0a4<EMCP,DOZE,DPM,ICE,DCE,SGE,BTIC,BHT>
real memory  = 125362176 (119 MB)
avail memory = 119640064 (114 MB)
nexus0: <Open Firmware Nexus device>
openpic0: <OpenPIC Interrupt Controller> on nexus0
unin0: <Apple UniNorth System Controller> on nexus0
unin0: Version 8
pcib0: <Apple UniNorth Host-PCI bridge> on nexus0
pci0: <PCI bus> on pcib0
pci0: <display, VGA> at device 16.0 (no driver attached)
pcib1: <Apple UniNorth Host-PCI bridge> on nexus0
pci1: <PCI bus> on pcib1
macio0: <KeyLargo I/O Controller> mem 0x80000000-0x8007ffff at device
23.0 on pci1
zs0: <Zilog Z8530> mem
0x13000-0x13fff,0x8400-0x84ff,0x8500-0x85ff,0x8600-0x86ff,0x8700-0x87ff
irq 22,23 on macio0
zs0: [FAST]
zs0: [FAST]
zstty0 on zs0
zstty1 on zs0
ata0 mem 0x1f000-0x1ffff,0x8a00-0x8aff irq 19 on macio0
ata1 mem 0x21000-0x21fff,0x8c00-0x8cff irq 21 on macio0
ohci0: <Apple KeyLargo USB controller> mem 0xa0002000-0xa0002fff irq 27
at device 24.0 on pci1
ohci0: [GIANT-LOCKED]
usb0: OHCI version 1.0
usb0: <Apple KeyLargo USB controller> on ohci0
usb0: USB revision 1.0
uhub0: Apple OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
ohci1: <Apple KeyLargo USB controller> mem 0xa0001000-0xa0001fff irq 28
at device 25.0 on pci1
ohci1: [GIANT-LOCKED]
usb1: OHCI version 1.0
usb1: <Apple KeyLargo USB controller> on ohci1
usb1: USB revision 1.0
uhub1: Apple OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
pci1: <bridge, PCI-CardBus> at device 26.0 (no driver attached)
pcib2: <Apple UniNorth Host-PCI bridge> on nexus0
pci2: <PCI bus> on pcib2
fwohci0: <1394 Open Host Controller Interface> mem 0xf5000000-0xf5000fff
irq 40 at device 14.0 on pci2
fwohci0: OHCI version 1.0 (ROM=0)
fwohci0: No. of Isochronous channels is 4.
fwohci0: EUI64 00:30:65:ff:fe:bf:ba:44
fwohci0: Phy 1394a available S400, 2 ports.
fwohci0: Link S400, max_rec 2048 bytes.
firewire0: <IEEE1394(FireWire) bus> on fwohci0
sbp0: <SBP-2/SCSI over FireWire> on firewire0
fwe0: <Ethernet over FireWire> on firewire0
if_fwe0: Fake Ethernet address: 02:30:65:bf:ba:44
fwe0: Ethernet address: 02:30:65:bf:ba:44
fwe0: if_start running deferred for Giant
fwohci0: Initiate bus reset
resCount = 4080 !?
fwohci0: node_id=0xc800ffc0, gen=1, CYCLEMASTER mode
plen(-4060) is negative! offset=4080
firewire0: 1 nodes, maxhop <= 0, Not found IRM capable node
gem0: <Apple GMAC Ethernet Adaptor> mem 0xf5200000-0xf53fffff irq 41 at
device 15.0 on pci2
miibus0: <MII bus> on gem0
bmtphy0: <BCM5201 10/100baseTX PHY> on miibus0
bmtphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
gem0: 10kB RX FIFO, 4kB TX FIFO
gem0: Ethernet address: 00:30:65:bf:ba:44
sc0: <System console> on nexus0
sc0: Unknown <16 virtual consoles, flags=0x300>
uhub2: vendor 0x0409 product 0x55ab, class 9/0, rev 1.00/1.00, addr 2
uhub2: 4 ports with 4 removable, bus powered
ukbd0: Alps Electric M2452, rev 1.00/1.01, addr 3, iclass 3/1
Timecounters tick every 10.000 msec
ad0: 9590MB <TOSHIBA MK1016GAP U1.13 A> at ata0-master BIOSPIO
Trying to mount root from ufs:/dev/ad0s11