Poudriere very slow when building in i386 jails

[Lorenzo Salvadore]

> Hi!
>
> > > SSD or spinning drives ?
> > >
> > > > I have 3.6 Gb of RAM and 2 Gb of swap.
> > >
> > > Run top and check the state of ARC.
> > > I think it needs much more RAM.
> >
> > I don't think it is a SSD (it has cylinders, sectors etc.).
> > If you can tell me a way to check it I will be glad to do it.
> > This is the output of diskinfo -v /dev/ada0 in case it answers the question:
> > /dev/ada0
> > 512 # sectorsize
> > 320072933376 # mediasize in bytes (298G)
> > 625142448 # mediasize in sectors
> > 4096 # stripesize
> > 0 # stripeoffset
> > 620181 # Cylinders according to firmware.
> > 16 # Heads according to firmware.
> > 63 # Sectors according to firmware.
> > HGST HTS545032A7E680 # Disk descr.
>
> This is a HGST drive, spinning, no SSD.
>
> > TMA45DZG06UX8R # Disk ident.
> > No # TRIM/UNMAP support
> > 5400 # Rotation rate in RPM
> > Not_Zoned # Zone Mode
> > These are are lines of top's header (poudriere is building one of the ports I think
> > might be problematic):
> > CPU: 32.8% user, 4.8% nice, 8.3% system, 0.5% interrupt, 53.5% idle
> > Mem: 1200M Active, 332M Inact, 32M Laundry, 2084M Wired, 187M Free
> > ARC: 1122M Total, 649M MFU, 323M MRU, 1371K Anon, 16M Header, 133M Other
> > 401M Compressed, 1064M Uncompressed, 2.65:1 Ratio
>
> So, when it's slow during builds, it's most probably swapping.

Thanks, I will try to work on avoiding using swap as much as possible.

Lorenzo Salvadore.