vr0: rx packet lost

[tony sarendal]

On 06/03/06, Andrea Venturoli <ml.diespammer at netfence.it> wrote:
>
> Vince Hoffman wrote:
> >
> > This may sound silly but if performance is that bad have you checked if
> > you have a Duplex mismatch ? (one side set to full manually and the
> > other to auto commonly results in duplex mismatches in my experience.
> > (see http://www.cites.uiuc.edu/network/autosense.html or use google for
> > more info)
>
> Hm, my switch isn't manageable, so it can't be set manually to
> full-duplex and must be using autosense.
> As for the card:
>
> > ifconfig vr0
> > vr0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
> >         inet 10.1.2.125 netmask 0xff000000 broadcast 10.255.255.255
> >         inet6 fe80::213:d4ff:fecc:a6a2%vr0 prefixlen 64 scopeid 0x1
> >         ether 00:13:d4:cc:a6:a2
> >         media: Ethernet autoselect (100baseTX <full-duplex>)
> >         status: active
>
> This was configured through rc.conf with:
>
> > ifconfig_vr0="DHCP"
>
>
> So I guess this is not the problem.


There are cases where equipment don't get along and
autoneg doesn't work. Try setting your end to 10M/half duplex
and see if you still have the problem.

/Tony