Intel Pro/1000 82540 Ethernet, was RE: SuperMicro X5DEI-GG
Guy Helmer
ghelmer at palisadesys.com
Thu May 15 14:59:25 PDT 2003
Originally I wrote to smp at freebsd.org:
> Has anyone had positive or negative experience with the
> SuperMicro X5DEI-GG
> dual-Xeon motherboard? It seems to work OK on a uniprocessor kernel, but
> FreeBSD 4.8 SMP kernels lock up after the "mounting root" message or after
> ifconfiging lo0 in the startup scripts. Our first machine may just be
> flaky, so I'll try another one as soon as possible...
I seem to have isolated the problems with SMP on this machine to the
built-in Intel Pro/1000 (82540) Ethernet interfaces. The machine *nearly*
freezes after ifconfig is run during startup. It can respond to the
keyboard
(accepting characters) the first few times I unplug/plug the Ethernet cable
from em0 and cause link down/up messages on the console. This only works a
few
times before the keyboard becomes completely unresponsive. I've tried a
4.8-RELEASE
and a 4.9-STABLE kernel cvsuped today. Any suggestions would be
appreciated.
> Machine details (dmesg, pciconf, mptable) follow.
>
> Thanks,
> Guy
>
> Guy Helmer, Ph.D., Sr. Software Engineer, Palisade Systems, Inc.
> http://www.palisadesys.com/~ghelmer/
>
> Copyright (c) 1992-2003 The FreeBSD Project.
> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
> The Regents of the University of California. All rights reserved.
> FreeBSD 4.8-RELEASE #23: Fri May 2 14:20:47 GMT 2003
> support at palisadesys.com:PH
> Timecounter "i8254" frequency 1193182 Hz
> CPU: Intel(R) Xeon(TM) CPU 2.80GHz (2800.12-MHz 686-class CPU)
> Origin = "GenuineIntel" Id = 0xf27 Stepping = 7
>
> Features=0xbfebfbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MT
> RR,PGE,MCA
> ,CMOV,PAT,PSE36,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,HTT,TM,PBE>
> Hyperthreading: 2 logical CPUs
> real memory = 536805376 (524224K bytes)
> avail memory = 518397952 (506248K bytes)
> Preloaded elf kernel "kernel.UP" at 0xc03d1000.
> Pentium Pro MTRR support enabled
> md0: Malloc disk
> Using $PIR table, 11 entries at 0xc00f4a50
> apm0: <APM BIOS> on motherboard
> apm0: found APM BIOS v1.2, connected at v1.2
> npx0: <math processor> on motherboard
> npx0: INT 16 interface
> pcib0: <ServerWorks host to PCI bridge(unknown chipset)> on motherboard
> pci0: <PCI bus> on pcib0
> em0: <Intel(R) PRO/1000 Network Connection, Version - 1.4.10> port
> 0xe000-0xe03f mem 0xfeb80000-0xfeb9ffff irq 9 at device 8.0 on pci0
> em0: Speed:100 Mbps Duplex:Half
> em1: <Intel(R) PRO/1000 Network Connection, Version - 1.4.10> port
> 0xe400-0xe43f mem 0xfeba0000-0xfebbffff irq 11 at device 9.0 on pci0
> em1: Speed:N/A Duplex:N/A
> pci0: <ATI Mach64-GR graphics accelerator> at 11.0 irq 10
> atapci0: <Generic PCI ATA controller> port
> 0xffa0-0xffaf,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7 at
> device 15.1
> on pci0
> ata0: at 0x1f0 irq 14 on atapci0
> ata1: at 0x170 irq 15 on atapci0
> ohci0: <OHCI (generic) USB controller> mem 0xfebfe000-0xfebfefff irq 10 at
> device 15.2 on pci0
> usb0: OHCI version 1.0, legacy support
> usb0: SMM does not respond, resetting
> usb0: <OHCI (generic) USB controller> on ohci0
> usb0: USB revision 1.0
> uhub0: (0x1166) OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
> uhub0: 4 ports with 4 removable, self powered
> isab0: <PCI to ISA bridge (vendor=1166 device=0227)> at device
> 15.3 on pci0
> isa0: <ISA bus> on isab0
> pcib255: <ServerWorks host to PCI bridge(unknown chipset)> on motherboard
> pci255: <PCI bus> on pcib255
> pcib1: <Host to PCI bridge> on motherboard
> pci1: <PCI bus> on pcib1
> orm0: <Option ROM> at iomem 0xc0000-0xc7fff on isa0
> fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
> fdc0: FIFO enabled, 8 bytes threshold
> fd0: <1440-KB 3.5" drive> on fdc0 drive 0
> atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
> atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
> kbd0 at atkbd0
> vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
> sc0: <System console> at flags 0x100 on isa0
> sc0: VGA <16 virtual consoles, flags=0x300>
> sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
> sio0: type 16550A
> sio1 at port 0x2f8-0x2ff irq 3 on isa0
> sio1: type 16550A
> ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
> ppc0: Generic chipset (ECP/PS2/NIBBLE) in COMPATIBLE mode
> ppc0: FIFO with 16/16/8 bytes threshold
> plip0: <PLIP network interface> on ppbus0
> lpt0: <Printer> on ppbus0
> lpt0: Interrupt-driven port
> ppi0: <Parallel I/O> on ppbus0
> ad0: 152627MB <WDC WD1600BB-00DAA0> [310101/16/63] at ata0-master BIOSDMA
> Mounting root from ufs:/dev/ad0s1a
> WARNING: / was not properly dismounted
> IP packet filtering initialized, divert disabled, rule-based forwarding
> enabled, default to deny, logging disabled
>
> pciconf:
> chip0 at pci0:0:0: class=0x060000 card=0x00000000
> chip=0x00171166 rev=0x32
> hdr=0x00
> chip1 at pci0:0:1: class=0x060000 card=0x00000000
> chip=0x00171166 rev=0x00
> hdr=0x00
> em0 at pci0:8:0: class=0x020000 card=0x004e8086 chip=0x100e8086 rev=0x02
> hdr=0x00
> em1 at pci0:9:0: class=0x020000 card=0x004e8086 chip=0x100e8086 rev=0x02
> hdr=0x00
> none0 at pci0:11:0: class=0x030000 card=0x00081002
> chip=0x47521002 rev=0x27
> hdr=0x00
> chip2 at pci0:15:0: class=0x060000 card=0x415515d9
> chip=0x02031166 rev=0xa0
> hdr=0x00
> atapci0 at pci0:15:1: class=0x01018a card=0x021211d9
> chip=0x02131166 rev=0xa0
> hdr=0x00
> ohci0 at pci0:15:2: class=0x0c0310 card=0x415515d9
> chip=0x02211166 rev=0x05
> hdr=0x00
> isab0 at pci0:15:3: class=0x060100 card=0x415515d9
> chip=0x02271166 rev=0x00
> hdr=0x00
>
> mptable:
>
> ==================================================================
> ==========
> ===
>
> MPTable, version 2.0.15
>
> ------------------------------------------------------------------
> ----------
> ---
>
> MP Floating Pointer Structure:
>
> location: BIOS
> physical address: 0x000ff780
> signature: '_MP_'
> length: 16 bytes
> version: 1.4
> checksum: 0xe4
> mode: Virtual Wire
>
> ------------------------------------------------------------------
> ----------
> ---
>
> MP Config Table Header:
>
> physical address: 0x000f0da0
> signature: 'PCMP'
> base table length: 324
> version: 1.4
> checksum: 0x7f
> OEM ID: 'AMI '
> Product ID: 'GCHE '
> OEM table pointer: 0x00000000
> OEM table size: 0
> entry count: 29
> local APIC address: 0xfee00000
> extended table length: 124
> extended table checksum: 17
>
> ------------------------------------------------------------------
> ----------
> ---
>
> MP Config Base Table Entries:
>
> --
> Processors: APIC ID Version State Family Model
> Step Flags
> 0 0x14 BSP, usable 15 2 7
> 0xbfebfbff
> 1 0x14 AP, usable 15 2 7
> 0xbfebfbff
> 2 0x14 AP, usable 15 2 7
> 0xbfebfbff
> 3 0x14 AP, usable 15 2 7
> 0xbfebfbff
> --
> Bus: Bus ID Type
> 0 PCI
> 1 ISA
> --
> I/O APICs: APIC ID Version State Address
> 8 0x11 usable 0xfec00000
> 9 0x11 usable 0xfec01000
> 10 0x11 usable 0xfec02000
> 11 0x11 usable 0xfec03000
> --
> I/O Ints: Type Polarity Trigger Bus ID IRQ APIC ID PIN#
> INT active-lo level 0 11:A 9 13
> INT active-lo level 0 15:A 9 1
> INT active-lo level 0 9:A 9 10
> INT active-lo level 0 8:A 9 12
> ExtINT active-hi edge 1 0 8 0
> INT active-hi edge 1 1 8 1
> INT active-hi edge 1 0 8 2
> INT active-hi edge 1 3 8 3
> INT active-hi edge 1 4 8 4
> INT active-hi edge 1 5 8 5
> INT active-hi edge 1 6 8 6
> INT active-hi edge 1 7 8 7
> INT active-hi edge 1 8 8 8
> INT active-hi edge 1 12 8 12
> INT active-hi edge 1 13 8 13
> INT active-hi edge 1 14 8 14
> INT active-hi edge 1 15 8 15
> --
> Local Ints: Type Polarity Trigger Bus ID IRQ APIC ID PIN#
> ExtINT active-hi edge 1 0 255 0
> NMI active-hi edge 0 0:A 255 1
>
> ------------------------------------------------------------------
> ----------
> ---
>
> MP Config Extended Table Entries:
>
> --
> System Address Space
> bus ID: 0 address type: I/O address
> address base: 0xd000
> address range: 0x2000
> --
> System Address Space
> bus ID: 0 address type: I/O address
> address base: 0x0
> address range: 0x100
> --
> System Address Space
> bus ID: 0 address type: memory address
> address base: 0xa0000
> address range: 0x20000
> --
> System Address Space
> bus ID: 0 address type: memory address
> address base: 0xfcb00000
> address range: 0x2100000
> --
> System Address Space
> bus ID: 0 address type: prefetch address
> address base: 0xfca00000
> address range: 0x100000
> --
> Bus Heirarchy
> bus ID: 1 bus info: 0x01 parent bus ID: 0
> --
> Compatibility Bus Address
> bus ID: 0 address modifier: add
> predefined range: 0x00000000
> --
> Compatibility Bus Address
> bus ID: 0 address modifier: add
> predefined range: 0x00000001
>
> ==================================================================
> ==========
> ===
More information about the freebsd-net
mailing list