help with ISDN line setup

[zytek-lists at nuxi.pl]

Hello list,

I need help with setting my ISDN line. It's my first contact with ISDN.

FreeBSD 6.2-RELENG_6_2, i4b and chan_capi from SVN.

I have working i4b and chan_capi installed. And.. I have no idea
what to do next. My ISDN line is working - I have plugged it to ISDN
phone and it worked fine. When I plug it into my card I have 
PH-state F3 - deactivated

I've experimentally put my card in pcm_master, then pcm_slave.
PH-state was then in F8: Lost framing, sometimes jumping for a second
to Synchronized or Active. Now it is again in F3 and stable. :)

[root at asterisk ~]# isdnconfig 
controller 0 = {
  Layer 1:
    description : HFC-2BDS0 128K PCI ISDN adapter
    type        : passive ISDN (Basic Rate, 2xB)
    channels    : 0x3
    serial      : 0xabcd
    power_save  : on
    dialtone    : enabled
    attached    : yes
    PH-state    : F3: Deactivated
  Layer 2:
    driver_type : DRVR_D_CHANNEL
}

When I run capitest -i 1 -o 1 I get this in dmesg:

i4b-L3 cd_set_state: cdid=384, persistent L1 deactivation - check ISDN
cable

I believe that before I proceed with asterisk configuration
I have to get isdn line working. But I have no idea what should I do,
what driver_type set up etc.

Currently there is another device connected to that ISDN line too,
maybe I should disconnect it before proceeding?

Any help would be appreciated. Thanks in advance!

--------------------------------------------------------------------
mail2web - Check your email from the web at
http://link.mail2web.com/mail2web