internet by call using i4b

[Andreas Gaertner]

hi,

i am trying to connect to arcor using fbsd 4.4-release and i4b 1.00.1. 
whenever i establish the connection everything seems ok, pap/chap is 
functioning, too, and /var/log/isdnd.log says 'switched to state 3' and 
i am also provided an ip-address but the remote peer remains at 0.0.0.1:

isp0: flags=8055<UP,DEBUG,POINTOPOINT,RUNNING,MULTICAST> mtu 1500
         inet 212.144.147.68 --> 0.0.0.1 netmask 0xffffffff
         ether 00:00:00:00:00:00

i am using

ifconfig isp0 0.0.0.0 0.0.0.1 netmask 0xffffffff
route add default -interface isp0

in my script as mentioned in the manpages.

my /etc/isdnd.rc looks as follows:

system

acctall         = on                    # generate info for everything
acctfile        = /var/log/isdnd.acct   # name & location of accounting 
file
useacctfile     = yes                   # generate accouting info to file

monitor-allowed = off                   # global switch: monitor on/off
ratesfile       = /etc/isdn/isdnd.rates # name & location of rates file
rtprio          = 25                    # modify isdnd's process priority

entry

name                    = arcorhdlc     # name for reference. This 
usrdevicename           = isp           # ipr, isp, tel, rbch
usrdeviceunit           = 0             # unit number
isdncontroller          = 0             # contoller to use or -1 to use 
isdnchannel             = 0             # channel (1/2) to use or 0 for 
direction               = out           # in, out, inout
local-phone-incoming    = *
remote-phone-incoming   = *
local-phone-dialout     = ******        # this is my number
remote-phone-dialout    = 01920781      # i call this remote number
dialin-reaction         = ignore        # accept, reject, ignore, answer, 
dialout-type            = normal        # normal / calledback
b1protocol              = hdlc          # hdlc, raw
ratetype                = 0             # ratesfile entry to use
unitlength              = 90            # unitlength to assume
unitlengthsrc           = rate          # none, rate, cmdl, conf, aocd
idletime-outgoing       = 60            # outgoing call idle timeout
earlyhangup             = 5             # time to hangup before an 
dialretries             = 3             # # of dial retries
connectprog             = "ip-up"
disconnectprog          = "ip-down"


any ideas? also, if i configure isp0 like with 'link1' it doesn't dial 
automatically, seems to not recognize the necessity to route towards the 
isdn interface.

thanks in advance, regards


-- 
 			captain at knus.de:
 	>> Very funny Scotty, but now beam down my clothes!! <<
 			http://www.knus.de