internet by call using i4b

[Anderl Gaertner]

hi,

i am trying to connect to arcor using fbsd 4.4-release and i4b 1.00.1. 
whenever i establish the connection everything seems ok, pap/chap is 
functioning, too, and
/var/log/isdnd.log says 'switched to state 3' and i am also provided an 
ip-address but the remote peer remains at 0.0.0.1:

isp0: flags=8055<UP,DEBUG,POINTOPOINT,RUNNING,MULTICAST> mtu 1500
         inet 212.144.147.68 --> 0.0.0.1 netmask 0xffffffff
         ether 00:00:00:00:00:00

i am using

ifconfig isp0 0.0.0.0 0.0.0.1 netmask 0xffffffff
route add default -interface isp0

in my script as mentioned in the manpages.

my /etc/isdnd.rc looks as follows:

system

acctall         = on                    # generate info for everything
acctfile        = /var/log/isdnd.acct   # name & location of accounting 
file
useacctfile     = yes                   # generate accouting info to file

monitor-allowed = off                   # global switch: monitor on/off
ratesfile       = /etc/isdn/isdnd.rates # name & location of rates file
rtprio          = 25                    # modify isdnd's process priority

entry

name                    = arcorhdlc     # name for reference. This 
usrdevicename           = isp           # ipr, isp, tel, rbch
usrdeviceunit           = 0             # unit number
isdncontroller          = 0             # contoller to use or -1 to use 
isdnchannel             = 0             # channel (1/2) to use or 0 for 
direction
= out           # in, out, inout
local-phone-incoming    = *
remote-phone-incoming   = *
local-phone-dialout     = ******        # this is my number
remote-phone-dialout    = 01920781      # i call this remote number
dialin-reaction         = ignore        # accept, reject, ignore, answer, 
dialout-type            = normal        # normal / calledback
b1protocol              = hdlc          # hdlc, raw
ratetype                = 0             # ratesfile entry to use
unitlength              = 90            # unitlength to assume
unitlengthsrc           = rate          # none, rate, cmdl, conf, aocd
idletime-outgoing       = 60            # outgoing call idle timeout
earlyhangup             = 5             # time to hangup before an 
dialretries             = 3             # # of dial retries
connectprog             = "ip-up"
disconnectprog          = "ip-down"


any ideas? also, if i configure isp0 like with 'link1' it doesn't dial 
automatically, seems to not recognize the necessity to route towards the 
isdn interface.

thanks in advance, regards


Mit freundlichen Gruessen

Anderl Gaertner 
Netzwerktechnologie
Zentrale Informatik
we make IT work!

KirchMedia GmbH & Co. KGaA
Tel. 089/9956 - 2805; Fax 089/9956 - 2803
mailto:Anderl.Gaertner at KirchGruppe.de
http://www.kirchgruppe.de