how dangerous would it be to switch to 5.1-current?

[un1du2el]

I've just tried to use an isppp setup with 5.1-R and the same thing 
happens. In fact it fails on first attempt, dials a second time, the 
connection is closed from the other side and the nothing ever happens 
again (no dialouts etc.).

Attached is a redirected log output from isdnd.

I use this card:
isic0 at port 0x1b00-0x1b1f,0x16e0-0x16ff,0x6e0-0x6ff,0xee0-0xeff, 
0x1300-0x131f,0x300-0x31f,0xb00-0xb1f irq 5 flags 0x4 on isa0
isic0: passive stack unit 0
isic0: AVM A1 or Fritz!Card Classic

The same setup works perfectly with 4.9-R.

Markus D.

Gary Jennejohn wrote:

> *This message was transferred with a trial version of CommuniGate(tm) Pro*
> 
> Markus Dolze writes:
> 
>>I have just tried to upgrade to 5.1-RELEASE (no patches yet).
>>
>>I use rbch to connect via user-land ppp (tun0). If I try to make a
>>connection, I get the error:
>>
>>Nov 19 00:16:23 <kern.crit> arwen kernel: i4b-L3 T303_timeout: SETUP not
>>answered, cr = 73
>>Nov 19 00:16:23 <kern.crit> arwen kernel: i4b-L3 next_l3state: FSM
>>illegal state, state = ST_U0 - Null, event = EV_T303EXP - T303 timeout!
>>
>>And the call is disconnected. PPP then tries to redial and the
>>connection is established.
>>
>>Attached are hints (from device.hints), kernel and isdnd.rc config
>>files. I use an old non-pnp AVM Fritz card (isic-driver).
>>
>>Any help?
>>
> 
> 
> Does this happen _every_ time?
> 
> Are you using rbch and ppp for channel bonding? If not I'd suggest
> using an isp interface. That's the way I do it.
> 
> ---
> Gary Jennejohn / garyj[at]jennejohn.org gj[at]freebsd.org gj[at]denx.de
> 
> _______________________________________________
> freebsd-isdn at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-isdn
> To unsubscribe, send any mail to "freebsd-isdn-unsubscribe at freebsd.org"
> 
> 
-------------- next part --------------
19.11.2003 23:10:08 DMN init_controller_state: controller 0 is AVM A1 or Fritz!Card
19.11.2003 23:10:08 DMN i4b isdn daemon started (pid = 203)
19.11.2003 23:10:10 DBG msg_dialout: dial req from isp, unit 0
19.11.2003 23:10:10 DBG setup_dialout: entry I4ARCOR ok!
19.11.2003 23:10:10 DBG find_by_device_for_dialout: found entry 0!
19.11.2003 23:10:10 DBG FSM event [msg-dialout]: [idle => dialing]
19.11.2003 23:10:10 DBG F_DIAL: local dial out request
19.11.2003 23:10:10 DBG select_first_dialno: only one no, no = 0192071
19.11.2003 23:10:10 CHD 00001 I4ARCOR rate 0 sec/unit (conf)
19.11.2003 23:10:10 DBG sendm_connect_req: ctrl = 0, chan = -1
19.11.2003 23:10:10 DBG decr_free_channels: ctrl 0, now 1 chan free
19.11.2003 23:10:10 CHD 00001 I4ARCOR dialing out from 8868907 to 0192071
19.11.2003 23:10:10 DBG msg_teiasg_ind: unit 0, tei = 70
19.11.2003 23:10:10 DBG msg_l12stat_ind: unit 0, layer 2, state 1
19.11.2003 23:10:11 CHD 00001 I4ARCOR outgoing call disconnected (remote)
19.11.2003 23:10:11 CHD 00001 I4ARCOR cause 43: Access information discarded (Q.850)
19.11.2003 23:10:11 ERR set_channel_busy: controller [0] invalid channel [-1]!
19.11.2003 23:10:11 DBG incr_free_channels: ctrl 0, now 2 chan free
19.11.2003 23:10:11 DBG F_DFL: dial fail, dial retry
19.11.2003 23:10:11 DBG select_next_dialno: only one no, no = 0192071
19.11.2003 23:10:11 DBG FSM (SUSE) event [msg-disc-ind]: [dialing => waitdialretry]
19.11.2003 23:10:16 DBG handle_reserved: entry I4ARCOR, dial retry request!
19.11.2003 23:10:16 DBG setup_dialout: entry I4ARCOR ok!
19.11.2003 23:10:16 CHD 00002 I4ARCOR rate 0 sec/unit (conf)
19.11.2003 23:10:16 DBG sendm_connect_req: ctrl = 0, chan = -1
19.11.2003 23:10:16 DBG decr_free_channels: ctrl 0, now 1 chan free
19.11.2003 23:10:16 CHD 00002 I4ARCOR dialing out from 8868907 to 0192071
19.11.2003 23:10:16 DBG set_channel_busy: controller [0] channel B1 set to BUSY!
19.11.2003 23:10:16 CHD 00002 I4ARCOR outgoing call proceeding (ctl 0, ch 0)
19.11.2003 23:10:17 DBG set_channel_busy: controller [0] channel B1 already busy!
19.11.2003 23:10:17 CHD 00002 I4ARCOR outgoing call active (ctl 0, ch 0, isp0)
19.11.2003 23:10:17 DBG FSM event [msg-con-act-ind]: [dialretry => connected]
19.11.2003 23:10:17 DBG F_DOK: dial out ok
19.11.2003 23:10:17 DBG select_this_dialno: index = 0, no = 0192071
19.11.2003 23:10:17 CHD 00002 I4ARCOR outgoing call disconnected (remote)
19.11.2003 23:10:17 CHD 00002 I4ARCOR cause 16: Normal call clearing (Q.850)
19.11.2003 23:10:17 CHD 00002 I4ARCOR charging: 0 units, 0 seconds
19.11.2003 23:10:17 CHD 00002 I4ARCOR accounting: in 133, out 103 (in 0, out 0)
19.11.2003 23:10:17 DBG set_channel_idle: controller [0] channel B1 set to IDLE!
19.11.2003 23:10:17 DBG incr_free_channels: ctrl 0, now 2 chan free
19.11.2003 23:10:17 DBG FSM event [msg-disc-ind]: [connected => idle]
19.11.2003 23:10:17 DBG F_IDIS: disconnect indication
19.11.2003 23:11:00 DMN daemon terminating, exitval = 0