9.0 on ProLiant G5
fhard at paz.bz
Tue Mar 13 07:06:29 UTC 2012
On 2012-03-12 11:27 AM, Hans Petter Selasky wrote:
> On Monday 12 March 2012 19:20:40 Alex Keda wrote:
>> On 12.03.2012 11:52, Hans Petter Selasky wrote:
>>> On Sunday 11 March 2012 17:40:42 Jim Pazarena wrote:
>>>> Alex Keda wrote, On 2011-12-04 10:46 AM:
>>>>> 03.12.2011 03:20, Jim Pazarena пишет:
> I see. Could you try 8.3 or 8-stable and see if that boots. I've backported
> most of the USB changes to 8-stable. If 8.3 boots, I believe it is not a USB
> problem, but ACPI or PCI most likely or something else.
just downloading 8.3RC1 now, and will burn and attempt install
my observations of 9.0 are:
when disabling 4. [A]CPI support and turning on 7. Boot [V]erbose,
I got a rather instant Automatic reboot:
panic: No usable event timer found!
cpuid = 0
KDB: stack backtrace:
#0 0xffffffff808680fe at kbd_backtrace+0x5e
Automatic reboot in 15 seconds
WHEN LEAVING [A]CPI Support: Enabled
usbus0: 12Mbps Full Speed USB v1.0
usbus1: 12Mbps Full Speed USB v1.0
usbus2: 480Mbps High Speed USB v2.0
ata2: hard reset ...
ata2: SATA connect timeout status=00000004
ata3: hard reset ...
ata3: SATA connect timeout status=00000004
ata4: hard reset ...
oodles of continuous:
ata0: stat1=0x80 err=0x80 lsb=0x80 msb=0x80
eventually followed with:
ata0: reset tp2 stat0=50 stat1=80 devices=0x1
(aprobe0:ata0:0:0:0): SIGNATURE: 0000
ata1: reset tp1 mask=00 ostat0=ff ostat1=ff
several more "(aprobe0:ata0:0:0:0): ... " messages
followed eventually with:
(aprobe:ata0:0:0:0): Error 5, Retries exhausted.
and a total system lockup requiring a power cycle
This is in verbose mode. Without verbose, the display
merely 'appears' to hang at the usb interrogation,
but now, seeing the above verbose output, it appears
to be ata errors instead.
More information about the freebsd-hardware