how to debug ath ?
dikshie
dikshie at gmail.com
Thu Sep 6 23:46:19 PDT 2007
hi,
any pointers how to debug ath device ?
my ath device is very strange.
with wpa auth my ath can only survice about 10 minutes after 10 minutes
my notebook become hang, i have to push it out and insert again, run
wpa_supplicant and dhclient again.
BUT if I turn off wpa auth in my wireless access point and run dhclient diretly
my ath card works normal.
by the way, I'm on non-acpi mode because acpi currently broken in my notebook.
(I'm using 7.0-current.)
my ath:
------------------------
ath0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 1500
ether 00:0a:79:6b:4e:cf
media: IEEE 802.11 Wireless Ethernet autoselect (autoselect)
status: no carrier
ssid "" channel 1 (2412 Mhz 11b)
authmode OPEN privacy OFF txpowmax 100 bmiss 7 scanvalid 60 bgscan
bgscanintvl 300 bgscanidle 250 roam:rssi11b 14 roam:rate11b 1 burst
------------------------
ath0 at pci2:0:0: class=0x020000 card=0xc1141259 chip=0x001b168c rev=0x01 hdr=0x00
vendor = 'Atheros Communications Inc.'
device = 'AR5006 family 802.11abg Wireless NIC'
class = network
subclass = ethernet
-------------------------
ath0: <Atheros 5212> mem 0x88000000-0x8800ffff irq 11 at device 0.0 on cardbus0
ath0: [ITHREAD]
ath0: using obsoleted if_watchdog interface
ath0: Ethernet address: 00:0a:79:6b:4e:cf
ath0: mac 10.5 phy 6.1 radio 6.3
--------------------------
my access point: corega wireless broadband access router (802.11a/b/g)
regards,
--
-dikshie-
More information about the freebsd-hardware
mailing list