skc0: unknown media type: 0x0
Bill Paul
wpaul at FreeBSD.ORG
Thu Nov 3 12:57:17 PST 2005
[Charset iso-8859-1 unsupported, filtering to ASCII...]
> > What do you have in /etc/rc.conf especially regarding ifconfig_sk0? _A
> > bad change there could easily results in the problem not showing up
> > until a reboot.
>
> The interface-detection fails during boot -- long before anything in rc.conf
> comes into play. It used to say:
>
> sk0: <Marvell Semiconductor, Inc. Yukon> on skc0
>
> It now says:
>
> skc0: unknown media type: 0x0
>
> and the interface is no longer available (nor listed by `ifconfig -a'). This
> may be a hardware problem, but it used to work just fine before :-(
>
> Thank you,
>
> -mi
Have you tried re-seating the card in its slot?
-Bill
--
=============================================================================
-Bill Paul (510) 749-2329 | Senior Engineer, Master of Unix-Fu
wpaul at windriver.com | Wind River Systems
=============================================================================
<adamw> you're just BEGGING to face the moose
=============================================================================
More information about the freebsd-hardware
mailing list