ATX boards and restart after power failure

[-|- Hurgh -|-]

Lol, just got this email just after i sent my last one,. so sorry to use up
the bandwidth :)

Have you tried getting a new firmware revision, it might have support for
it??

-|- Hurgh -|-


__________________________
Website: http://www.hurgh.org/
Forums: http://forums.hurgh.org/



----- Original Message ----- 
From: "Bob Lockie" <bjlockie at lockie.ca>
Cc: <freebsd-hardware at freebsd.org>
Sent: Wednesday, May 14, 2003 1:06 PM
Subject: Re: ATX boards and restart after power failure


> On 05/13/03 22:45 Bob Lockie spoke thusly
>
> >
> > Does anybody remember this topic?
> >
> > DATE: 10/19/1998 02:35:30
> > SUBJECT: RE:  ATX boards and restart after power failure
> >
> > I have an Asus P5A r1.04 mainboard that I want to use for a server but
> > it does not reboot after a power failure.
> > r1.06 of the P5A does but that doesn't help me.
> >
> > Did anybody find a work around?
> > I've contacted Asus but I expect them to just say that I am out of luck
> > with the revision board that I have.
>
> I wasn't clear.
> The BIOS setting for this is not selectable because it is not supported
> on the revision of the mainboard that I have (1.04).
> It was later added to revision 1.06 of the mainboard but that doesn't
> help me.
>
>
> _______________________________________________
> freebsd-hardware at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-hardware
> To unsubscribe, send any mail to
"freebsd-hardware-unsubscribe at freebsd.org"
>