9-beta1 installer - partition editor

[Ivan Voras]

On 31/08/2011 02:40, Nathan Whitehorn wrote:
> On 08/30/11 19:07, Ivan Voras wrote:


>> It was a plain install on a RAID volume which appears as ordinary da0
>> drive. I did do a couple of start-overs so it could be that some state
>> got lost. It definitely did NOT show mount points in the dialog which
>> lists newly created partitions.
>>
>
> Which partitioning scheme did you use? How did you lay out the partitions?

I did not deviate from defaults until the partition editor, where I 
deleted existing partitions (Linux) and tried to create new ones.

So, it's a MBR scheme, and I intended to create three partitions, for 
"/", for "/srv" and a swap partition. I think Andrey's idea about what 
went wrong with the swap partition is most probably correct, so this 
only leaves the inability to register mount points with the partitions.

However, if as Brandon suggested this is already fixed, don't bother. 
I'll try the BETA2 when ISOs become available and will post screenshots 
(IPMI) if it fails again.