Western Digital 1TB My Book Studio
Stephen Bader
sbader at comcast.net
Fri Jul 18 20:29:58 UTC 2008
-> camcontrol devlist -v
scbus0 on sbp0 bus 0:
< > at scbus0 target -1 lun -1 ()
scbus-1 on xpt0 bus 0:
< > at scbus-1 target -1 lun -1 (xpt0)
-------------- Original message ----------------------
From: Sean Bruno <sbruno at miralink.com>
> Stephen Bader wrote:
> > No, it only has a single drive in it.
> >
> > -Steve
> >
> > -------------- Original message ----------------------
> > From: Sean Bruno <sbruno at miralink.com>
> >
> >> Stephen Bader wrote:
> >>
> >>> Here is the output with the sysctl variables set. I'm at work right now, so
> I
> >>>
> >> couldn't physically disconnect and reconnect, but I did issue a 'fwcontrol
> -r'
> >> to get this output. If you need an actual disconnect/reconnect, it'll have to
> >> wait a few hours.
> >>
> >>> -Steve
> >>>
> >>> fwohci0: Initiate bus reset
> >>> fwohci0: BUS reset
> >>> fwohci0: node_id=0xc800ffc1, gen=15, CYCLEMASTER mode
> >>> firewire0: 2 nodes, maxhop <= 1, cable IRM = 1 (me)
> >>> firewire0: bus manager 1 (me)
> >>> sbp0:0:0 request timeout(mgm orb:0x2e10b154) ... reset start
> >>> fwohci0: Initiate bus reset
> >>> fwohci0: fwphy_rddata: 0x1 loop=1, retry=0
> >>> fwohci0: fwphy_rddata: 0x1 loop=1, retry=0
> >>> fwohci0: BUS reset
> >>> sbp_post_busreset
> >>> fwohci0: node_id=0xc800ffc1, gen=16, CYCLEMASTER mode
> >>> firewire0: 2 nodes, maxhop <= 1, cable IRM = 1 (me)
> >>> fwohci0: fw_set_bus_manager: 1->1 (loop=0)
> >>> firewire0: bus manager 1 (me)
> >>> send phy_config root_node=1 gap_count=5
> >>> fwohci0: start AT DMA status=72
> >>> node0: crom unchanged
> >>> fw_explore: node 2, err = 0
> >>> bus_explore done
> >>> sbp_post_explore (sbp_cold=0)
> >>> sbp_post_explore: EUI:0090a9341b93f349 attached
> >>> target 0 lun 0 found
> >>> target 0 lun 1 found
> >>> sbp0:0:0 ordered:1 type:0 EUI:0090a9341b93f349 node:0 speed:3 maxrec:0 new!
> >>> sbp0:0:0 'WD' 'My Book' '001025'
> >>> sbp_login: sec = 0 usec = 683278 ticks = 683
> >>> sbp0:0:1 ordered:1 type:13 EUI:0090a9341b93f349 node:0 speed:3 maxrec:0 new!
> >>> sbp0:0:1 'WD' 'My Book' '001025'
> >>> sbp_login: sec = 0 usec = 682496 ticks = 682
> >>> sbp0:0:1 LOGIN
> >>> sbp: alloc 3 xfer
> >>> sbp0:0:1 mgm orb: 2c4ad28c
> >>> sbp0:0:0 LOGIN
> >>> sbp0:0:1 request timeout(mgm orb:0x2c4ad28c) ... reset start
> >>> sbp0:0:1 sbp_reset_start
> >>>
> >>>
> >>> -------------- Original message ----------------------
> >>> From: Sean Bruno <sbruno at miralink.com>
> >>>
> >>>
> >>>> Stephen Bader wrote:
> >>>>
> >>>>
> >>>>> Is there anything I can do to help you out? I'd hate for you to go buy a
> >>>>>
> >> drive
> >>
> >>>>>
> >>>>>
> >>>> just to help me get mine working.
> >>>>
> >>>>
> >>>>> -Steve
> >>>>>
> >>>>> -------------- Original message ----------------------
> >>>>> From: Sean Bruno <sbruno at miralink.com>
> >>>>>
> >>>>>
> >>>>>
> >>>>>> Stephen Bader wrote:
> >>>>>>
> >>>>>>
> >>>>>>
> >>>>>>> Here is a link to the manufacturers site for the drive:
> >>>>>>>
> >>>>>>> http://www.westerndigital.com/en/products/products.asp?driveid=374
> >>>>>>>
> >>>>>>> Thanks,
> >>>>>>>
> >>>>>>> -Steve
> >>>>>>>
> >>>>>>> -------------- Original message ----------------------
> >>>>>>> From: Sean Bruno <sbruno at miralink.com>
> >>>>>>>
> >>>>>>>
> >>>>>>>
> >>>>>>>
> >>>>>>>>> It works just fine in Windows and on Mac. I haven't tried linux yet,
> >>>>>>>>> but if it comes down to it, I can probably find a live CD somewhere
> >>>>>>>>> and try it out.
> >>>>>>>>>
> >>>>>>>>> Here is the output of 'fwcontrol -p'.
> >>>>>>>>>
> >>>>>>>>> Thanks,
> >>>>>>>>>
> >>>>>>>>> -Steve
> >>>>>>>>>
> >>>>>>>>>
> >>>>>>>>>
> >>>>>>>>>
> >>>>>>>>>
> >>>>>>>> Let me see what "beta mode" means.
> >>>>>>>>
> >>>>>>>> Also, can you link me to the manufacturer's web site for the specific
> >>>>>>>> model you have?
> >>>>>>>>
> >>>>>>>>
> >>>>>>>>
> >>>>>>>>
> >>>>>>>>
> >>>>>>>>> === base register ===
> >>>>>>>>> 0x07 0x85 0xe3 0xe2 0xc4 0x03 0x10 0x00
> >>>>>>>>> Physical_ID:1 R:1 CPS:1
> >>>>>>>>> RHB:1 IBR:0 Gap_Count:5
> >>>>>>>>> Extended:7 Num_Ports:3
> >>>>>>>>> PHY_Speed:7 Delay:2
> >>>>>>>>> LCtrl:1 C:1 Jitter:0 Pwr_Class:4
> >>>>>>>>> WDIE:0 ISBR:0 CTOI:0 CPSI:0 STOI:0 PEI:0 EAA:1 EMC:1
> >>>>>>>>> Max_Legacy_SPD:0 BLINK:1 Bridge:0
> >>>>>>>>> Page_Select:0 Port_Select0
> >>>>>>>>>
> >>>>>>>>> === page 0 port 0 ===
> >>>>>>>>> 0xf8 0x60 0x3b 0x00 0x00 0x00 0x00 0x00
> >>>>>>>>> Astat:3 BStat:3 Ch:1 Con:0 RXOK:0 Dis:0
> >>>>>>>>> Negotiated_speed:3 PIE:0 Fault:0 Stanby_fault:0 Disscrm:0 B_Only:0
> >>>>>>>>> DC_connected:0 Max_port_speed:3 LPP:1 Cable_speed:3
> >>>>>>>>> Connection_unreliable:0 Beta_mode:0
> >>>>>>>>> Port_error:0x0
> >>>>>>>>> Loop_disable:0 In_standby:0 Hard_disable:0
> >>>>>>>>>
> >>>>>>>>> === page 0 port 1 ===
> >>>>>>>>> 0xfe 0x60 0x3b 0x08 0x00 0x00 0x00 0x00
> >>>>>>>>> Astat:3 BStat:3 Ch:1 Con:1 RXOK:1 Dis:0
> >>>>>>>>> Negotiated_speed:3 PIE:0 Fault:0 Stanby_fault:0 Disscrm:0 B_Only:0
> >>>>>>>>> DC_connected:0 Max_port_speed:3 LPP:1 Cable_speed:3
> >>>>>>>>> Connection_unreliable:0 Beta_mode:1
> >>>>>>>>> Port_error:0x0
> >>>>>>>>> Loop_disable:0 In_standby:0 Hard_disable:0
> >>>>>>>>>
> >>>>>>>>> === page 0 port 2 ===
> >>>>>>>>> 0xf8 0x60 0x3b 0x00 0x00 0x00 0x00 0x00
> >>>>>>>>> Astat:3 BStat:3 Ch:1 Con:0 RXOK:0 Dis:0
> >>>>>>>>> Negotiated_speed:3 PIE:0 Fault:0 Stanby_fault:0 Disscrm:0 B_Only:0
> >>>>>>>>> DC_connected:0 Max_port_speed:3 LPP:1 Cable_speed:3
> >>>>>>>>> Connection_unreliable:0 Beta_mode:0
> >>>>>>>>> Port_error:0x0
> >>>>>>>>> Loop_disable:0 In_standby:0 Hard_disable:0
> >>>>>>>>>
> >>>>>>>>> === page 1 ===
> >>>>>>>>> 0x02 0x00 0x08 0x00 0x28 0x83 0x13 0x04
> >>>>>>>>> Compliance:2
> >>>>>>>>> Vendor_ID:0x080028
> >>>>>>>>> Product_ID:0x831304
> >>>>>>>>>
> >>>>>>>>>
> >>>>>>>>>
> >>>>>>>>>
> >>>>>>>>>
> >>>>>>>>>
> >>>>>>>>>
> >>>>>>>>>> --
> >>>>>>>>>> Sean Bruno
> >>>>>>>>>> MiraLink Corporation
> >>>>>>>>>> 6015 NE 80th Ave, Ste 100
> >>>>>>>>>> Portland, OR 97218
> >>>>>>>>>> Cell 503-358-6832
> >>>>>>>>>> Phone 503-621-5143
> >>>>>>>>>> Fax 503-621-5199
> >>>>>>>>>> MSN: sbruno at miralink.com
> >>>>>>>>>> Google: seanwbruno at gmail.com
> >>>>>>>>>>
> >>>>>>>>>>
> >>>>>>>>>>
> >>>>>>>>>>
> >>>>>>>>>>
> >>>>>>>> --
> >>>>>>>> Sean Bruno
> >>>>>>>> MiraLink Corporation
> >>>>>>>> 6015 NE 80th Ave, Ste 100
> >>>>>>>> Portland, OR 97218
> >>>>>>>> Cell 503-358-6832
> >>>>>>>> Phone 503-621-5143
> >>>>>>>> Fax 503-621-5199
> >>>>>>>> MSN: sbruno at miralink.com
> >>>>>>>> Google: seanwbruno at gmail.com
> >>>>>>>>
> >>>>>>>>
> >>>>>>>>
> >>>>>>>>
> >>>>>>>>
> >>>>>>>
> >>>>>>>
> >>>>>>>
> >>>>>>>
> >>>>>> Thanks. I _think_ that my local CostCo has them in stock.
> >>>>>>
> >>>>>> Sean
> >>>>>>
> >>>>>> --
> >>>>>> Sean Bruno
> >>>>>> MiraLink Corporation
> >>>>>> 6015 NE 80th Ave, Ste 100
> >>>>>> Portland, OR 97218
> >>>>>> Phone 503-621-5143
> >>>>>> Fax 503-621-5199
> >>>>>> MSN: sbruno at miralink.com
> >>>>>> Google: seanwbruno at gmail.com
> >>>>>>
> >>>>>>
> >>>>>>
> >>>>>>
> >>>>>
> >>>>>
> >>>>>
> >>>> Maybe this well give me a clue. Set a couple of sysctl variables and
> >>>> then send me the output when connecting the hard drive:
> >>>> debug.sbp_debug --> 1
> >>>> debug.firewire_debug --> 1
> >>>>
> >>>> Sean
> >>>>
> >>>>
> >>>> --
> >>>> Sean Bruno
> >>>> MiraLink Corporation
> >>>> 6015 NE 80th Ave, Ste 100
> >>>> Portland, OR 97218
> >>>> Phone 503-621-5143
> >>>> Fax 503-621-5199
> >>>> MSN: sbruno at miralink.com
> >>>> Google: seanwbruno at gmail.com
> >>>>
> >>>>
> >>>>
> >>>
> >>>
> >> Does this device actually have 2 drives in it?
> >>
> >> Sean
> >>
> >> --
> >> Sean Bruno
> >> MiraLink Corporation
> >> 6015 NE 80th Ave, Ste 100
> >> Portland, OR 97218
> >> Phone 503-621-5143
> >> Fax 503-621-5199
> >> MSN: sbruno at miralink.com
> >> Google: seanwbruno at gmail.com
> >>
> >>
> >
> >
> what do you get with a "camcontol devlist -v"?
>
> Sean
>
> --
> Sean Bruno
> MiraLink Corporation
> 6015 NE 80th Ave, Ste 100
> Portland, OR 97218
> Phone 503-621-5143
> Fax 503-621-5199
> MSN: sbruno at miralink.com
> Google: seanwbruno at gmail.com
>
More information about the freebsd-firewire
mailing list