[amd64] Reproducible cold boot failure (reboot succeeds) in
-CURRENT
John Baldwin
jhb at freebsd.org
Thu Nov 17 16:33:35 UTC 2011
On Thursday, November 17, 2011 3:59:43 am Stefan Esser wrote:
> Am 16.11.2011 17:16, schrieb John Baldwin:
> > On Sunday, November 13, 2011 12:56:12 pm Stefan Esser wrote:
> >> ...
> >> WARNING: WITNESS option enabled, expect reduced performance.
> >> Table 'FACP' at 0xba918a58
> >> Table 'APIC' at 0xba918b50
> >> Table 'SSDT' at 0xba918be8
> >> Table 'MCFG' at 0xba918dc0
> >> Table 'HPET' at 0xba918e00
> >> ACPI: No SRAT table found
> >> Preloaded elf kernel "/boot/kernel/kernel" at 0xffffffff81109000
> >> Preloaded elf obj module "/boot/kernel/zfs.ko" at 0xffffffff81109370 <--
> >> kldload: unexpected relocation type 67108875
> >> kernel trap 12 with interrupts disabled
> >>
> >> The irritating detail is the load address of "zfs.ko", which is just
> >> 0x370 bytes above the kernel load address ...
> >
> > That isn't unusual. Those are the addresses of the metadata provided by the
> > loader, not the base address of the kernel or zfs.ko object themselves. The
> > unexpected relocation type is interesting however. That value in hex is
> > 0x400000b. 0xb is the R_X86_64_32S relocation type which is normal for the
> > kernel. I think you just have a single-bit memory error due to a failing
> > DIMM.
>
> Thanks for the information about the load address semantics. The other
> unexpected relocation type I observed was 268435457 == 0x10000001, which
> also hints at a single bit error. But today the system failed with a
> different error:
>
> ath0: ...
> ioapic0: routing interrupt 18 to ...
> panic: vm_page_insert: page already inserted
>
> This could of course also be caused by a single bit error ...
Yes, very likely.
> Hmmm, perhaps there is a problem with components at room temperature
> and the system is still significantly warmer after 3 hours?
Yes, I strongly suspect it is a thermal effect that the RAM "works" once it
is warmed up. If you have data you care about on the machine, I would just
go ahead and replace the RAM now before waiting for the RAM's failure to
become worse.
--
John Baldwin
More information about the freebsd-current
mailing list