if_re does not work
Yoshikazu GOTO
goto at snowy.to
Wed Jul 12 01:14:57 UTC 2006
Hi Warner,
In Message-ID: <20060711.154453.-1632629843.imp at bsdimp.com>
"M. Warner Losh" <imp at bsdimp.com> wrote :
> In message: <20060711.144929.74705658.imp at bsdimp.com>
> Warner Losh <imp at bsdimp.com> writes:
> : > > > In theory the bus_alloc_resource(.., SYS_RES_IRQ, ...) should route an
> : > > > interrupt for the re0 device but it won't show up in the probe line in that
> : > > > case since the probe line is printed before re_attach() is called. In fact,
> : > > > in the failing case, it wasn't bus_alloc_resource() that failed, but
> : > > > bus_setup_intr(). This is most likely not an re0 issue however.
> : > > >
> : > > > goto-san, can you add printf's to i386/i386/intr_machdep.c:intr_add_handler()
> : > > > and kern/kern_intr.c:intr_event_add_handler() to see which of the EINVAL
> : > > > cases is being triggered?
> : > >
> : > > I added printf() to 2 functions (one in intr_add_handler() and two
> : > > in intr_event_add_handler()) and re-build my kernel and reboot my
> : > > ThinkPad X40. But I could not get any printf's messages.
> : > >
> : > > And I have a question. Why INTR_FAST was added in re_attach()?
> : > > When I deleted it and re-build if_re modules, my card was attached.
> : >
> : > INTR_FAST added because the driver was converted to use 'fast' interrupts.
> : >
> : > I really hope nobody's going to tell me that INTR_FAST isn't supported with
> : > cardbus.
> :
> : INTR_FAST isn't supported with cardbus at the moment.
> :
> : However, that decision dates from a time when you couldn't share fast
> : and non-fast interrupts. Cardbus necessarily shared its function
> : interrupt with its card status change interrupt (since there's only
> : one interrupt pin on the cardbus bridge). I'll investigate what it
> : takes to make this happen given the current new-world order. I have
> : at least one re cardbus card, I think, so I can do testing.
>
> You can try the following patch. It just papers over the problem...
Thank you for your reply and patch.
I tried it, but I caught error messages as follows:
---- start ----
<< boot sequence (dhclient on em0) >>
re0: link state changed to DOWN
panic: mutex re0 not owned at /usr/src/sys/kern/kern_mutex.c:405
cpuid = 0
KDB: enter: panic
[thread pid 414 tid 100054 ]
Stopped at kdb_enter+0x2b: nop
db>
---- end ----
Goto.
-=-=-=-
// Yoshikazu GOTO
// E-mail: goto at snowy.to
-=-=-=-
\e
More information about the freebsd-current
mailing list