Possible fxp(4) problem in -CURRENT

[Mike Tancsa]

At 05:46 AM 17/10/2005, Dan Bilik wrote:
>through it. It seems to be the same problem as described in PR
>amd64/82425 with one exception - there is no 'device timeout' in logs.

Its been a long time since I have seen

fxp0: Disabling dynamic standby mode in EEPROM
fxp0: New EEPROM ID: 0x48a0
fxp0: EEPROM checksum @ 0x3f: 0xf0f7 -> 0xf0f7


But, I seem to recall that when the driver detects this bug in the 
fxp card, you need to power cycle the box.  But after that, you 
should never see the message again.  On my old (i810) boards, I think 
I would only see this problem in 10baseT mode, and 100 would not be 
an issue (or perhaps the other way around, but its been a long time 
and I dont recall exactly).

Not sure if thats your issue or not, or if the driver is incorrectly 
seeing that bug in your rev of the fxp.  If thats the case, perhaps 
work around it by modifying the code to not try and program the phy like it is.

         ---Mike