IRQ-Routing for 5.3-BETA
Matthias Schuendehuette
msch at snafu.de
Thu Nov 11 07:34:19 PST 2004
Hello Nate,
Am Dienstag, 9. November 2004 06:25 schrieb Nate Lawson:
> I MFC'd the change to RELENG_5 as well so if you can test there or on
> 6-current, you should fine that the card works as before. The change
> was to allow the SCI (irq 9 on PIC systems) to always be used for
> devices, even if the ACPI _PRS setting for the device doesn't
> explicitly allow it.
I tried this in the moment but there's no change concerning my
ISDN-Card. The isic(4)-device attaches either to IRQ9 or to IRQ10
(depending on my /boot/device.hints config), so the dmesg seems ok in
either case... but the card *works* only on IRQ9.
There are no other devices on IRQ9 (or IRQ10 resp.), but somehow these
two Interrupt-lines behave differently.
I have no problem with this any more since I found out that the card is
working on IRQ9. I hope this remains for FreeBSD-5 at least... :-)
--
Ciao/BSD - Matthias
Matthias Schuendehuette <msch [at] snafu.de>, Berlin (Germany)
PGP-Key at <pgp.mit.edu> and <wwwkeys.de.pgp.net> ID: 0xDDFB0A5F
More information about the freebsd-current
mailing list