serial ata on freebsd 5.2.1 or current
Evren Yurtesen
yurtesen at ispro.net.tr
Sun Mar 7 10:50:17 PST 2004
I use two drives, I am sure there are i/o requests on both drives. I use
squid cache with diskd and hyperthreading is enabled.
No errors whatsoever. I use ICH5 on the board only. Not the ViA, but ViA
was working fine though, just changed motherboard because the previous
one supported only 3 memory slots.
Putinas Piliponis wrote:
> Do you use one disk drive or two ? What about more I/O on both disks
> same time?
>
> ----- Original Message ----- From: "Evren Yurtesen" <yurtesen at ispro.net.tr>
> To: "Putinas Piliponis" <putinas.piliponis at icnspot.net>
> Cc: <current at freebsd.org>
> Sent: Sunday, March 07, 2004 10:32
> Subject: Re: serial ata on freebsd 5.2.1 or current
>
>
>> Putinas Piliponis wrote:
>>
>>> Hi all,
>>> Is there any serial ata controller which works stable with 5.2.1 or
>>> Current ?
>>> I had tried SiI3112A and Intel ICH5 both knocks system to panic or
>>> lockup.
>>> ( ICH5 I tried only on 5.2.1-RELEASE , 3112 from yesterday current
>>> and release as well )
>>
>>
>>
>> ICH5 works fine. I also used one integrated ViA.
>>
>> If ICH5 is crashing, you should maybe check from the bios SATA
>> settings. I got it working by disabling the 'enchanced mode' off for
>> ich5.
>>
>> Evren
>>
>>
>>
>
>
More information about the freebsd-current
mailing list