nForce2 RAID MCP (SATA) support?

[John Nielsen]

On Wednesday 22 December 2004 11:08 pm, Brooks Davis wrote:
> On Wed, Dec 22, 2004 at 08:48:31PM -0700, John Nielsen wrote:
> > What would be needed to simply have the controller recognized
> > and able to support UDMA 150 (or even 133)?
>
> At least in current, there's an nForce2 MCP device id that is supposed
> to support UDMA6 so I suspect you may just need to wait a bit and it
> will arrive.  It's possiable you have a board with a non-standard
> PCI-id.  You might make sure "pciconf -lv" shows that your controler
> shows a device ID of 0x008510de.  If not, you may be a simple matter of
> adding it to the necessicary two lines.

Thanks, I'll try booting off a -current snapshot and see what shows up.

JN