bge on IBM xSeries 335 with FreeBSD 6.0
Lin, Tsung Ching
tclin at iis.sinica.edu.tw
Thu Apr 27 04:04:22 UTC 2006
hi all,
I installed FreeBSD 6.0-Release on a IBM xSeries 335.
It works fine while installing.
After finishing intalling, i try to enable bge1 using the folling
command
# ifconfig bge1 inet 192.168.0.1 netmask 255.255.255.0
then the box jus hangs. no any messages.
i have to press "reset" to reboot it.
the system hangs too when i add the following line in /etc/rc.conf
ifconfig_bge1="inet 192.168.0.1 netmask 255.255.255.0"
even i just used "ifconfig bge1 up", the system hangs too.
I had tried it on several IBM xSeries 335 machines.
the results are all the same.
how can i deal with this proplem.
thank you.
bge0: <Broadcom BCM5703 Gigabit Ethernet, ASIC rev. 0x1002> mem
0xf9ff0000-0xf9ffffff irq 24 at device 1.0 on pci2
miibus0: <MII bus> on bge0
brgphy0: <BCM5703 10/100/1000baseTX PHY> on miibus0
brgphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseTX,
1000baseTX-FDX, auto
bge0: Ethernet address: 00:09:6b:a3:24:9e
bge1: <Broadcom BCM5703 Gigabit Ethernet, ASIC rev. 0x1002> mem
0xf9fe0000-0xf9feffff irq 25 at device 2.0 on pci2
miibus1: <MII bus> on bge1
brgphy1: <BCM5703 10/100/1000baseTX PHY> on miibus1
brgphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseTX,
1000baseTX-FDX, auto
bge1: Ethernet address: 00:09:6b:a3:24:9f
--
Lin, Tsung Ching
Institute of Information Science, Academia Sinica
Taiwan, R. O. C.
More information about the freebsd-bugs
mailing list