bin/51586: rsh/rshd connect problem (select: protocol failurein circuit setup)

[LarsKöller]

The following reply was made to PR bin/51586; it has been noted by GNATS.

From: Lars =?iso-8859-1?Q?K=F6ller?= <Lars.Koeller at uni-bielefeld.de>
To: freebsd-gnats-submit at FreeBSD.org
Cc: Lars.Koeller at uni-bielefeld.de, ianf at za.uu.net, silby at silby.com,
	Jeffrey Hsu <hsu at FreeBSD.org>,
	mark tinguely <tinguely at web.cs.ndsu.nodak.edu>
Subject: Re: bin/51586: rsh/rshd connect problem (select: protocol failure in
 circuit setup)
Date: Wed, 14 May 2003 09:08:05 +0200

 --------
 
 Hi,
 
 I can't find any firmware or PXE Software for the Board, even on intel =
 
 nor MSI site.
 
 So I'm not able to solve the problem with the em-Interface on this =
 
 board.
 
 It's hard to belive it is the Cisco switch port, cause the same port =
 
 with the same 100 MBit full duplex works with the fxp driver/chip of =
 
 the second interface very well.
 
 However it is even hard to belive, that the 82540 intel chip on the =
 
 board is working incorrect on all 7 boards.
 
 So perhaps it is the em-driver?
 
 Any ideas?
 
 Best regards
 
 Lars
 
 -- =
 
 E-Mail: Lars.Koeller at Uni-Bielefeld.DE        \  Lars K=F6ller
             lkoeller at FreeBSD.org              \  CC University of
 PGP: http://www.uk.pgp.net/pgpnet/wwwkeys.html \  Bielefeld, Germany =
 
      Key-ID: A430D499                           \  Tel: +49 521 106 4964
 ----------- FreeBSD, what else? ---- http://www.freebsd.org -------------=