is wireguard available on arm64

[Ronald Klop]

Hello Peter,

Good to hear that it works.
For the bugreport. You could try to mail the maintainer of the port.
See https://www.freshports.org/net/wireguard/ or https://www.freshports.org/net/wireguard-go/ for the email address of the maintainer.
If the maintainer does not reply you can create a bug report at https://bugs.freebsd.org/.

Regards,
Ronald.

 
Van: Peter Libassi <peter at libassi.se>
Datum: dinsdag, 14 januari 2020 17:42
Aan: freebsd-arm at freebsd.org
Onderwerp: Re: is wireguard available on arm64
> 
> I managed to compile (after adding swap space) and install go-devel and the wireguard bits on the RPI3. I also installed the packages on a second RPI3. Set up a wireguard tunnel between the RPI3's using wg-quick and run iperf test.
> 
> iperf direct on the local lan: 94.1 Mbits/sec
> iperf over the wireguard tunnel: 71.1 Mbits/sec
> 
> 
> The wg(8) man page references man pages that do not exist on freebsd, where should I file a bug report?
> 
> 
> _______________________________________________
> freebsd-arm at freebsd.org mailing list
> https://lists.freebsd.org/mailman/listinfo/freebsd-arm
> To unsubscribe, send any mail to "freebsd-arm-unsubscribe at freebsd.org"
> 
> 
>