Status of FreeBSD CAM/MMC/SDIO?

[Patrick Crilly]

I was wondering if anyone knew what the current state of CAM/MMC/SDIO 
driver for Raspberry Pi is?

I followed this link https://wiki.freebsd.org/SDIO and checked out 
FreeBSD current.
I build a kernel using the GENERIC-MMCCAM conf file.

dmesg produced the following regarding SDIO -

> (mmcprobe0:sdhci_slot0:0:0:0): Probe PROBE_SEND_IF_COND to 
> PROBE_SDIO_RESET
> (mmcprobe0:sdhci_slot0:0:0:0): Start with PROBE_SDIO_RESET
> (mmcprobe0:sdhci_slot0:0:0:0): SDIO_RESET: error 1, CCCR CTL register: 
> 00000000
> (mmcprobe0:sdhci_slot0:0:0:0): Probe PROBE_SDIO_RESET to PROBE_SDIO_INIT
> (mmcprobe0:sdhci_slot0:0:0:0): Start with PROBE_SDIO_INIT
> (mmcprobe0:sdhci_slot0:0:0:0): SDIO_INIT: error 1, 00000000 00000000 
> 00000000 00000000
> (mmcprobe0:sdhci_slot0:0:0:0): Probe PROBE_SDIO_INIT to 
> PROBE_SEND_APP_OP_COND

The output from camcontrol is

> root at generic:~ # camcontrol devlist -v
> scbus0 on sdhci_slot0 bus 0:
> <SDHC SC16G 8.0 SN 6BEFCB84 MFG 02/2018 >  at scbus0 target 0 lun 0 
> (pass0,sdda0)
> scbus-1 on xpt0 bus 0:
> <>                                 at scbus-1 target -1 lun ffffffff 
> (xpt0)

Thanks,
Patrick.

-- 
"With great power comes great electricity bill"