Solid-run cubox-i or hummingboard

[Bernd Walter]

On Mon, Oct 13, 2014 at 08:39:01PM -0600, Ian Lepore wrote:
> On Mon, 2014-10-13 at 20:28 -0400, Tom Pusateri wrote:
> > Does anyone have a bootable img for the solid run i.MX6 (armv7) based boards?
> > 
> > The Hummingboard is for sale now on New Egg. It has an mSATA port ($99 model) and gigabit ethernet so it's going to be a fast little board.
> > 
> > I see in the snapshot directories, support for Beaglebone, pandaboard, RPi, and zedboard. I assume none of these will work.
> > 
> 
> We're not yet quite to the point where a generic imx6 kernel can run on
> any board using vendor-supplied fdt data, but it shouldn't be too hard
> to start with the wandboard config and create dts files that describe
> those boards.  The current state of imx6 support is detailed here:
> 
>  https://wiki.freebsd.org/FreeBSD/arm/imx6

I have the two bigger hummingboards (and a bunch of other iMX6).
In about 2-3 weeks I should have manged to free up enough time to
see if I can boot them.
fdt differences about IO used for SD, console, ... are obvious and
clear.
But what is required at uboot level?

-- 
B.Walter <bernd at bwct.de> http://www.bwct.de
Modbus/TCP Ethernet I/O Baugruppen, ARM basierte FreeBSD Rechner uvm.