Connecting to Beablebone

[hiren panchasara]

On Sat, May 11, 2013 at 9:11 AM, Tim Kientzle <kientzle at acm.org> wrote:
>
> On May 11, 2013, at 12:59 AM, hiren panchasara wrote:
>
>> I found one of these:
>> http://www.amazon.com/gp/product/B006JKNWLE/ref=oh_details_o06_s00_i00?ie=UTF8&psc=1
>>
>> And I've connected it to laptop as shown in:
>> http://www.strugglingcoder.info/pics/bb1.jpg
>> and on beaglebone as shown in: http://www.strugglingcoder.info/pics/bb2.jpg
>>
>> As per the schematic info I derived:
>> Pin 1: GND
>> Pin 4: RX
>> Pin 5: TX
>>
>> I can still not see anything after connecting to "cu -l cuaU0".
>
> You probably need to set the speed:
>
>   cu -s 115200 -l cuaU0

Doesn't seem to help. I've been following instructions at
https://wiki.freebsd.org/FreeBSD/arm/BeagleBoneBlack

Hiren
>
> Tim
>