Unable to copy DTB into module directory

[Alie Tan]

On Fri, Feb 22, 2013 at 2:57 PM, Werner Thie <werner at thieprojects.ch> wrote:

> On 2/22/13 7:47 AM, Alie Tan wrote:
>
>> On Fri, Feb 22, 2013 at 2:17 PM, Tim Kientzle <tim at kientzle.com> wrote:
>>
>>
>>> On Feb 21, 2013, at 10:07 PM, Tim Kientzle wrote:
>>>
>>>  On Feb 21, 2013, at 9:50 PM, Alie Tan wrote:
>>>>
>>>>>
>>>>> I just built RasPi image and keeps getting this message:
>>>>>
>>>>> "unable to copy DTB into module directory"
>>>>>
>>>>> then the raspi reboot again and again.
>>>>>
>>>>
>>>> Try backing out r247045 and see if that fixes
>>>> it for you.
>>>>
>>>> Also try breaking into the U-Boot prompt
>>>> and entering
>>>>
>>>
>>> Sorry, left out some steps here.  (To clarify, this is a separate
>>> experiment to be done with an image that includes
>>> r247045).  The instructions should say:
>>>
>>>    1) Remove the "fdt addr 0x100" command from loader.rc
>>>
>>>    2) Early in boot, break to the U-Boot prompt (hit any key during the
>>> 3-second countdown)
>>>
>>>  I can't even hit any key on my keyboard. What to do now?
>>
>
> Are you on USB/serial console? 256MB RPi? No reset button?
>

I am on video console connected to HDMI, 512MB RPI


> If so, it's very tricky to bring cu up and sneak in a keystroke (not ENTER
> though)
>
> Fiddling with the power and cu usually takes a few attempts for me
>
> Werner
>
>