GlobalScale DreamPlug + FreeBSD 8.2 release

[Naoyuki Tai]

Hello,

I'm new to the FreeBSD/arm, bought a DreamPlug from GlobalScale,
hoping to turn it into a FreeBSD file server.

I followed the "http://wiki.freebsd.org/FreeBSDMarvell", and created
kernel.bin. After giving it a "go", it hangs.

I must have built the kernel.bin wrong but I have no clue as to what
I did wrong.
Any clue/help is appreciated.

Thanks!

-- Tai

U-Boot 2011.06-02334-g8f495d9-dirty (May 31 2011 - 02:06:26)
Marvell-DreamPlug

SoC:   Kirkwood 88F6281_A0
CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz
DRAM:  512 MiB
SF: Detected MX25L1606 with page size 256, total 1 MiB
In:    serial
Out:   serial
Err:   serial
Net:   egiga0, egiga1
88E1116 Initialized on egiga0
88E1116 Initialized on egiga1
Hit any key to stop autoboot:  0
Marvell>> setenv serverip 192.168.10.3
Marvell>>  setenv ipaddr 192.168.10.55
Marvell>>  tftpboot 6400000 arm/kernel.bin
Using egiga0 device
TFTP from server 192.168.10.3; our IP address is 192.168.10.55
Filename 'arm/kernel.bin'.
Load address: 0x6400000
Loading: #################################################################
          #################################################################
          #################################################################
          ############################
done
Bytes transferred = 3272884 (31f0b4 hex)
Marvell>> go  0x6400000
## Starting application at 0x06400000 ...