AT91RM9200: USB broken? No!

[Greg Ansley]

It's a QFP so the errors are OK.

Turned out to be a bad solder joint on pin 1 of the USB connector 
(power). Connector on this card is not very mechanically stable with the 
mounting posts going into huge worthless holes. :-(

Error messages were just a red herring, after not having seen them for 
weeks while working on the SAM9G20.

Greg

On 7/20/10 9:58 AM, Bernd Walter wrote:
> So it looks like your device isn't noticed as being connected at all,
> which is a bit strange because your error messages clearly show that
> it got the faulty device connected from the secondary port.
>
>