Application not working when Power OFF/ON is done while on reset its working

[neha_makhija]

M. Warner Losh wrote:
> 
> In message: <7943626.post at talk.nabble.com>
>             neha_makhija <neha.makhija at honeywell.com> writes:
> : I am working on AT91RM9200 development board with ecos ported over it. I
> : have burnt the flash with the redboot image. When i turn off the board
> and
> : then turn it ON then the code doesnt work and doesnt show anything on
> the
> : hyperterminal. But if i reset the board then the code is working fine.
> 
> I'm guessing something is wrong with the power up sequence such that
> the boot flash isn't quite right by the time the AT91RM9200 starts its
> boot sequence.
>>>>> The problem is not with the boot sequence because when the power is
>>>>> turned ON then it displays all the details related to the hardware
>>>>> initialization but later it stucks sumwhere and that hardware is not
>>>>> configured fully.
> But when i reset it then again it displays the whole details regarding the
> hardware initialization and then this time it doesnt stuck anywhere.
> Any idea y it is happening .
> 
> 
> : Can u please suggest me the possible reason alongwith the solution of
> this
> : problem as soon as possible.
> 
> There is only one solution: install FreeBSD :-).  It has nothing to do
> with your problem, but will solve all your other problems.
> 
> Neha
> _______________________________________________
> freebsd-arm at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-arm
> To unsubscribe, send any mail to "freebsd-arm-unsubscribe at freebsd.org"
> 
> 

-- 
View this message in context: http://www.nabble.com/Application-not-working-when-Power-OFF-ON-is-done-while-on-reset-its-working-tf2844769.html#a7985193
Sent from the freebsd-arm mailing list archive at Nabble.com.