Application not working when Power OFF/ON is done while on reset its working

[M. Warner Losh]

In message: <7943626.post at talk.nabble.com>
            neha_makhija <neha.makhija at honeywell.com> writes:
: I am working on AT91RM9200 development board with ecos ported over it. I
: have burnt the flash with the redboot image. When i turn off the board and
: then turn it ON then the code doesnt work and doesnt show anything on the
: hyperterminal. But if i reset the board then the code is working fine.

I'm guessing something is wrong with the power up sequence such that
the boot flash isn't quite right by the time the AT91RM9200 starts its
boot sequence.

: Can u please suggest me the possible reason alongwith the solution of this
: problem as soon as possible.

There is only one solution: install FreeBSD :-).  It has nothing to do
with your problem, but will solve all your other problems.

Warner