5.0.18: "Bad scbptr 255 during SELTO"

[Doug Ledford]

Elgin Lee wrote:
> 
> I just installed Linux kernel 2.0.34, updated with the 5.0.18 Adaptec
> driver.  This setup seems to work reasonably so far, except that I
> often get error messages like
> 
>     (scsi0:-1:-1:-1) Bad scbptr 255 during SELTO.
>     (scsi0:-1:-1:-1) Referenced SCB 255 not valid during SELTO.
>             SCSISEQ = 0x12 SEQADDR = 0xb SSTAT0 = 0x10 SSTAT1 = 0x8a
> 
> during startup.  This is not always the case, however--sometimes I
> get what looks like a success message:
> 
>     (scsi0:-1:-1:-1) Allocating initial 30 SCB structures.
> 
> Are the error messages something that I should be concerned about?

Well, you shouldn't need to be, I am.  Give the 5.0.19 driver a shot.  It's
on my ftp site at ftp.dialnet.net.

-- 

 Doug Ledford  <dledford at dialnet.net>
  Opinions expressed are my own, but
     they should be everybody's.

To Unsubscribe: send mail to majordomo at FreeBSD.org
with "unsubscribe aic7xxx" in the body of the message