6.0-RC1 on Promise SX4060 (SETFEATURES FAILURE, READ timed out)
Xin LI
delphij at gmail.com
Thu Nov 3 23:04:25 PST 2005
Hi, Mark,
On 11/4/05, Mark Kirkwood <markir at paradise.net.nz> wrote:
[snip]
> Tried Safe mode with 6.0-RC1 (no boot menu so had to read beastie.4th to
> figure out how to do that):
>
> (loader)
> set hint.acpi.0.disabled = 1
> set loader.acpi_disabled_by_user = 1
> set hint.apic.0.disabled = 1
> set hw.ata.ata_dma = 0
> set hw.ata.atapi_dma = 0
> set hw.ata.wc = 0
> #set hw.eisa_slots = 0 (forgot to type this one... I'll try again with
> it in)
>
> and get exactly the same errors.
>
> Also tried 5.4-RELEASE CD booted in safe mode:
>
> acd0: CDRW <CREATIVE CD-RW RW8439E/1R09> at ata1-master PIO4
> ad4: FAILURE - ATA_IDENTIFY timed out
> ad4: FAILURE - ATA_IDENTIFY timed out
>
> Fatal trap 12: page fault while in kernel mode
> fault virtual address = 0x8
> fault code = supervisor write, page not present
> instruction pointer = 0x8:0xc05db50d
> stack pointer = 0x10:0xe6befc94
> frame pointer = 0x10:0xe6befc9c
> code segment = base 0x0, limit 0xfffff, type 0x1b
> = DPL 0, pres 1, def32 1, gran 1
> processor eflags = intrupt enabled, resume, IOPL = 0
> current process = 5 (thread taskq)
> trap number = 12
> panic: page fault
Oops, this is beyond my knowledge. If you have a serial console line
to connect to your box, then do it and try to record the output of
"boot -v" would be helpful.
I have Cc'ed this mail to Soren (our ATA guru) and he may have some suggestions.
Cheers,
More information about the freebsd-current
mailing list